Config 802.11A Enable; Config 802.11A Rate - Alcatel OmniAccess Wireless System 2.1 Product Manual

Note that the Standalone WPS Alcatel OmniAccess Wireless System described in About the Alcatel
OmniAccess Wireless System in the Alcatel OmniAccess Wireless Product Guide does not support
WLANs or DTIM parameters.
To change the DTIM value for the whole 802.11a network, use the config 802.11a dtim command.
config 802.11a dtim <value>
>
Syntax
Defaults
Examples
Related Commands

config 802.11a enable

Enable 802.11a transmissions for the whole network or for an individual OmniAccess AP 1200 or 1250
using the config 802.11a enable command. You must use this command to enable the network after
configuring other 802.11a parameters.
Note that this command only enables the Alcatel 802.11a network. To disable the 802.11a, 802.11b
and/or 802.11g networks for an individual WLAN, use the config wlan radio command.
This command can be used any time the CLI interface is active.
config 802.11a enable {network/<OmniAccess AP 1200 or 1250>}
>
Syntax
Defaults
Examples
Related Commands

config 802.11a rate

To set 802.11a mandatory and supported operational rates, use the config 802.11a rate command.
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 64
config
802.11a
dtim
<value>
1 (every beaconperiod)
>config 802.11a dtim 2
to configure the 802.11a network to transmit multicast and broadcast
messages every other DTIM, or beaconperiod.
show 802.11a, config 802.11a beaconperiod, config 802.11b dtim, config
802.11a disable, config 802.11a enable
config 802.11a enable
config
802.11a
enable
network
<OmniAccess AP 1200 or 1250>Override the network setting for an individual
Network = enabled.
To enable the whole 802.11a network:
>config 802.11a enable network
To enable AP1 802.11a transmissions:
>config 802.11a enable AP1
show sysinfo, show 802.11a, config wlan radio, config 802.11a disable, config
802.11b disable, config 802.11b enable, config 802.11b 11gSupport enable,
config 802.11b 11gSupport disable
config 802.11a rate
Configure parameters.
802.11a network parameters.
Delivery Traffic Indication Map.
DTIM value in number of beaconperiods.
Configure parameters.
802.11a network parameters.
Enable 802.11a.
For the whole network.
<OmniAccess AP 1200 or 1250> OmniAccess Radio.
config 802.11a enable