Alcatel OmniAccess Wireless System 2.1 Product Manual page 715

Table -
General (Continued)
Parameter
Admin Status
Site Config ID
Table -
Antenna
Parameter
Antenna Mode
Antenna Type
Table -
WLAN Override
Parameter
WLAN Override
Note that the Standalone WPS Alcatel OmniAccess Wireless System described in About the Alcatel
OmniAccess Wireless System in the Alcatel OmniAccess Wireless Product Guide does not support
Third-Party APs.
Performance Profile
•
"
To view/edit Performance Profile parameters for this AP interface,
Monitor Access Points > AP > <name> > 802.11x > Perf.
Table -
RF Channel Assignment
Parameter
Current Channel
Assignment Method
11/5/04 Configure Access Points > Access Point > <name> > 802.11a
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 136
Check to box to indicate the administration state of the OmniAccess AP
1200 or 1250 as enabled.
Site identification number.
Omni, Sector A, Sector B.
Internal or external antennas
Enable, Disable. When you enable WLAN Override, Alcatel OmniAccess
Operating System displays a table showing all current Alcatel WLANs. In
the table, select WLANs to enable WLAN operation, and deselect WLANs to
disallow WLAN operation for this 802.11a OmniAccess Radio.
Channel number of the OmniAccess AP 1200 or 1250.
Channels may be set either globally by the Alcatel OmniAccess Switch or
Appliance or locally Check a circle for Global or Custom (when checked,
from the pulldown menu, select one of the following: 36, 40, 44, 48, 52,
56, 60, 64, 149, 159, 157, 161.
Description
Description
Description
click here
Profile.
Description
" Refer to
.