Alcatel OmniAccess Wireless System 2.1 Product Manual page 507

Table -
General Details (Continued)
Parameter
Port Number
Location
Primary Switch
Name
Statistics Timer
After the OmniAccess AP 1200 or 1250 is reset, it attempts to connect with its Primary Alcatel
Note:
OmniAccess Switch or Appliance as configured on this page. If the OmniAccess AP 1200 or 1250's
Primary Alcatel OmniAccess Switch or Appliance is not available, it searches for the Master Alcatel
OmniAccess Switch or Appliance
OmniAccess Switch or Appliance on the network.
Table -
AP Interface Details
Parameter
Number of
interfaces
Interface Type
Admin Status
Oper Status
Hardware Reset Button
•
Click the Reset AP Now button to reset the OmniAccess AP 1200 or 1250.
Versions
Versions
•
Displays the Alcatel OmniAccess Operating System Software and Boot ROM versions.
Inventory Information
Inventory Information
•
Displays the OmniAccess AP 1200 or 1250 Model Number.
•
Displays the OmniAccess AP 1200 or 1250 Serial Number.
•
Displays whether or not OmniAccess AP 1200R or 1250R (OmniAccess AP 1200R or 1250R)
Mode is supported.
Set to Factory Defaults Button
•
Click the Clear Config button to reset the OmniAccess AP 1200 or 1250 parameters to the
factory defaults.
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 58
The OmniAccess AP 1200 or 1250 is connected to this Alcatel OmniAccess
Switch or Appliance port.
Customer-definable location name for the OmniAccess AP 1200 or 1250.
This is the OmniAccess AP 1200 or 1250's Primary Alcatel OmniAccess Switch
or Appliance SNMP name. The OmniAccess AP 1200 or 1250 attempts to
associate with this Alcatel OmniAccess Switch or Appliance first for all network
operations and in the event of a hardware reset (Note).
This counter sets the time in seconds that the OmniAccess AP 1200 or 1250
sends its DOT11 statistics to the Alcatel OmniAccess Switch or Appliance.
(Master Switch
One or Two 802.11a and/or 802.11b/g interfaces.
Displays the OmniAccess Radio type: either 802.11a or 802.11b/g.
Displays the OmniAccess Radio interface status: either enabled or disabled.
Displays the OmniAccess Radio operational status: either UP or DOWN.
Hardware Reset Button
Hardware Reset Button
Description
Configuration) and finally the least loaded Alcatel
Description
OmniAccess APs > Details