Alcatel OmniAccess Wireless System 2.1 Product Manual page 184

Switch or Appliance configuration to the ACS Software database, and then returns you to the
Add Switch page.
Note:
the selected IP Address, the Discovery Status page displays a
device, check SNMP. . .
rectly (refer to
unable to contact the Alcatel OmniAccess Switch or Appliance (make sure that you
can ping the Alcatel OmniAccess Switch or Appliance from the ACS Server and retry),
or the device has different SNMP settings (verify that the SNMP settings match and
retry).
•
You may now add additional Alcatel OmniAccess Switches and Appliances in the Add Switch
page, or click the Configure Tab to have the ACS Web Interface display the All Switches page.
You have added Alcatel OmniAccess Switches or Appliances to the ACS Software database. Continue
Using the Alcatel OmniAccess Control System
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 143
If ACS Software does not find an Alcatel OmniAccess Switch or Appliance at
message. Either the
Configuring Other Ports and
Service Port
Parameters), or ACS Software was
Software.
Configuring the ACS Database
No response from
IP Address is set incor-