Config Network Otap-Mode; Config Network Peer-Blocking; Config Network Rf-Mobility-Domain - Alcatel OmniAccess Wireless System 2.1 Product Manual

Examples
Related Commands

config network otap-mode

To enable or disable over-the-air provisioning (OTAP) of OmniAccess AP Access Points and/or Omni-
Access 1200R APs, use the config network otap-mode command.
>config network otap-mode [enable/disable]
Syntax
Defaults
Examples
Related Commands

config network peer-blocking

Disabled allows same-subnet clients to communicate through the Alcatel OmniAccess Switch or Appli-
ance. Enabled (default) forces same-subnet clients to communicate through a higher-level router. To
enable or disable peer blocking, use the config network peer-blocking command.
>config network peer-blocking [enable/disable]
Syntax
Defaults
Examples
Related Commands

config network rf-mobility-domain

To set the RF mobility group domain name, use the config network rf-mobility-domain command.
>config network rf-mobility-domain <name>
Syntax
Defaults
Examples
Related Commands
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 124
>config network multicast enable
show network
config network otap-mode
config
network
otap-mode
[enable/disable]
Enabled.
>config network otap-mode disable
show network
config network peer-blocking
config
network
peer-blocking
[enable/disable]
Disabled.
>config network peer-blocking enable
show network
config network rf-mobility-domain
config
network
rf-mobility-domain
<name>
(none)
>config network params 172.1.1.1 255.255.255.0
show network
Configure parameters.
Network parameters.
Over-the-air OmniAccess AP 1200 or 1250 and
OmniAccess AP 1200R or 1250R provisioning.
Change the OTAP state.
Configure parameters.
Network parameters.
Peer communications requirement.
Change the peer-blocking state.
Configure parameters.
Alcatel OmniAccess Switch or Appliance network
parameter.
Mobility group domain.
Mobility group name.
config network otap-mode