Step 1: Collecting Required Tools and Supplies
•
One OmniAccess AP 1200 or 1250 or OmniAccess AP 1200R or 1250R per location.
•
One optional OmniAccess AP 1200 or 1250 Ceiling-Mount Bezel Kit for each location.
•
Optional AC-to-DC external power supplies, factory-orderable. Note that this option requires
the power cable to be run through the plenum in a metal conduit to meet safety requirements.
•
Map showing OmniAccess AP 1200 or 1250 locations, and mounting and power options.
•
Large razor knife or keyhole saw for cutting ceiling tile.
•
Screwdrivers and ladder.
•
CAT-5 (or higher) cables to connect the OmniAccess AP 1200 or 1250 and OmniAccess AP
1200R or 1250R locations and the Alcatel OmniAccess WLAN Switch or other network device.
•
Optional wire to secure each OmniAccess AP 1200 or 1250 inside the ceiling.
Continue with
Step 2: Configuring the OmniAccess AP 1200 or 1250 Before
Step 2: Configuring the OmniAccess AP 1200 or 1250 Before
Installation
Step 2: Configuring the OmniAccess AP 1200 or 1250 Before Installation
These procedures are designed to make sure that your OmniAccess AP 1200 or 1250 physical installa-
tion goes smoothly and that initial operation is as expected.
Refer to the appropriate OmniAccess AP 1200 or 1250 Quick Installation Guide for instructions.
Continue with
Step 3: Installing the Ceiling-Mount Bezel Kit and OmniAccess AP 1200 or
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide
Step 1: Collecting Required Tools and Supplies
Step 1: Collecting Required Tools and Supplies
Installation.
1250.
4