Configure <Ipaddr> > Telnet Ssh Configuration; Configure <Ipaddr> > Syslog Configuration - Alcatel OmniAccess Wireless System 2.1 Product Manual

Table -
WPS Traps
Trap Name
Rogue Auto
Containment
Command Buttons
•
Save: Save the current settings.
•
Audit: Discover the present status of this AP.
Configure <IPaddr> > Telnet SSH Configuration
Use CONFIGURE/Switches, click an IP address under the IP Address column, then on the left sidebar
menu click Management/Telnet SSH to access this page.
Use this page to modify Telnet SSH accessibility to the Alcatel OmniAccess Switch or Appliance:
•
Template Name: Name of this template.
•
Session Timeout (minutes): This object indicates the number of minutes a Telnet session is
allowed to remain inactive before being logged off. A zero means there will be no timeout. May
be specified as a number from 0 to 160. The factory default is 5.
•
Maximum Sessions: Selectable from a pulldown menus for values of from 0 to 5. This object
indicates the number of simultaneous Telnet sessions allowed. The factory default is 5.
•
Allow New Sessions: Indicates that new Telnet sessions will not be allowed on the DS Port when
set to no. The factory default value is no.
Note:
New Telnet sessions are always allowed on the Service port.
•
Allow New SSH Sessions: Indicates that new Secure Shell Telnet sessions will not be allowed
when set to no. The factory default value is yes.
Command Buttons
•
Save: Data is sent to the Alcatel OmniAccess Switch or Appliance and made to take effect, but
not preserved across a power cycle; these parameters are stored temporarily in volatile RAM.
•
Audit: Discover the present status of this AP.
Configure <IPaddr> > Syslog Configuration
Use CONFIGURE/Switches, click an IP address under the IP Address column, then on the left
sidebar menu click Management/Syslog to access this page.
This page allows you to disable and enable an Alcatel OmniAccess Switch or Appliance syslog:
•
Template Name: User-defined name of this template.
•
Syslog Enabled: checkbox.
Command Buttons
•
Save: Data is sent to the Alcatel OmniAccess Switch or Appliance and made to take effect, but
not preserved across a power cycle; these parameters are stored temporarily in volatile RAM.
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 223
Notification sent when the Alcatel OmniAccess Switch or Appliance
automatically contains a rogue AP.
New Telnet sessions can be allowed or disallowed on the DS (network) port.
Configure <IPaddr> > Telnet SSH Configuration
Description
Configure <IPaddr> > Telnet SSH Configuration
Configure <IPaddr> > Syslog Configuration