•
Password: Password to access the certificate.
Command Buttons
•
OK
•
Cancel
Configure <IPaddr> > Download Configuration to Switch
Use CONFIGURE/Switches, click an IP Address under the IP Address column, then on the left
sidebar menu click System/Commands, and from the Upload/Download Commands pulldown
select Download Config to access this page.
Use this command to download and install a configuration file to your Alcatel OmniAccess Switch or
Appliance from a local TFTP (trivial file transfer protocol) server.
Note:
TFTP servers cannot run on the same workstation as the ACS Software, because the
ACS Software and the third-party TFTP servers use the same communication port.
•
IP Address: IP Address of the Alcatel OmniAccess Switch or Appliance.
•
Status: Status of the certificate, for example, NOT_INITIATED.
TFTP Servers
•
Server Name: Use the pulldown to select Default Server or New. When you select New, type in
the IP Address.
•
Server Address: IP Address of the server.
•
Maximum Retries: How many times ti retry if the download fails.
•
Timeout: How long to allow between retries.
•
File Name: Enter or select the filename to download using the Browse button.
•
OK
•
Cancel
Configure Download Software to Switch
Use CONFIGURE/Switches, click an IP Address under the IP Address column, then on the left
sidebar menu click System/Commands, and from the Upload/Download Commands pulldown,
select Download Software to access this page.
Use this command to download and install new Alcatel OmniAccess Switch or Appliance Alcatel Omni-
Access Operating System software to your Alcatel OmniAccess Switch or Appliance from a local TFTP
(trivial file transfer protocol) server.
Note:
TFTP servers cannot run on the same workstation as the ACS Software, because the
ACS Software and the third-party TFTP servers use the same communication port.
•
IP Address: IP Address of the Alcatel OmniAccess Switch or Appliance to receive the software.
•
Current Software Version: The software version currently running on the Alcatel OmniAccess
Switch or Appliance.
•
Status: Status of the software, for example, NOT_INITIATED.
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 232
The ACS Software uses an integral TFTP server. This means that third-party
The ACS Software uses an integral TFTP server. This means that third-party
Configure <IPaddr> > Download Configuration to Switch
Configure <IPaddr> > Download Configuration to Switch
Configure Download Software to Switch
Need help?
Do you have a question about the OmniAccess Wireless System 2.1 and is the answer not in the manual?
Questions and answers