Configure Trap Receiver > New Template; Configure Trap Controls > New Template - Alcatel OmniAccess Wireless System 2.1 Product Manual

•
Signal Measurement Interval: The interval (in seconds) for strength measurements at each
OmniAccess AP 1200 or 1250. Default is 300 seconds.
•
Noise Measurement Interval: The interval (in seconds) for noise and interference measure-
ments at each OmniAccess AP 1200 or 1250. Default is 300 seconds.
•
Load Measurement Interval: The interval (in seconds) for load measurements at each
OmniAccess AP 1200 or 1250. Default is 300 seconds.
•
Coverage Measurement Interval: The interval (in seconds) for coverage measurements at each
OmniAccess AP 1200 or 1250. Default is 300 seconds.
Command Buttons
•
Save
•
Cancel
Configure Trap Receiver > New Template
Use CONFIGURE/Templates, from the left sidebar menu under Management select Trap
Receivers, then from the Select a command pulldown select Add Template to access this page.
This page allows you to create a new trap receiver template.
Table -
New Trap Receiver Template
Parameter
Template Name
No. of Switches Applied To
IP Address
Admin Status
Command Buttons
•
Save
•
Cancel
Configure Trap Controls > New Template
Use CONFIGURE/Templates, from the left sidebar menu, under Management select Trap Control,
then from the Select a command pulldown select Add Template to access this page.
This page allows you to add a new trap control template:
•
Template Name: Type in the name of the new template.
•
No of Switches Applied to: Number of Alcatel OmniAccess Switches and Appliances to which this
template is applied (read only).
Check the boxes as desired.
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 159
Configure Trap Receiver > New Template
User-defined name of this new template.
Number of Alcatel OmniAccess Switches and Appliances to which this
template is applied (read only).
The IP Address of the server.
Status must be enabled for the SNMP traps to be sent to the receiver.
Enabled checkbox.
Configure Trap Controls > New Template
Configure Trap Receiver > New Template
Description