Configure <Ipaddr> > Connected Third Party Ap > New; Configure <Ipaddr> > Ntp Servers > Add From Template - Alcatel OmniAccess Wireless System 2.1 Product Manual

Table -
Connected Third-Party AP
Parameter
Checkbox
IP Address
MAC Address
802.1X Required
Switch Port Number
Select a command
Make a selection and click GO:
•
Add Third-Party AP: Refer to
•
Delete Third-Party APs: Check the AP(s) to be deleted, select this command and click GO.
Configure <IPaddr> > Connected Third Party AP > New
Use CONFIGURE/Switches and click an IP address under the IP Address column, then on the left
sidebar menu, select Access Points and click Third Party APs, then from the Select a command
pulldown, select Add Third Party AP to access this page.
Note that the Standalone WPS Alcatel OmniAccess Wireless System described in About the Alcatel
OmniAccess Wireless System in the Alcatel OmniAccess Wireless Product Guide does not support
Third-Party APs.
This page allows you to add a new connected Third-Party AP after the third-party WLAN (WLAN 17) is
configured using Configure <IPaddr> > WLAN > Add From
•
IP Address: IP Address of the Third-Party AP.
•
MAC Address: MAC Address of the Third-Party AP.
•
Switch Port Number: OmniAccess Wireless Switch port number used by the Third-Party AP.
•
802.1x Required: Click the box to require 802.1x.
•
Mirror Mode: Disable or Enable.
Command Buttons
•
Save
•
Cancel
Configure <IPaddr> > NTP Servers > Add From Template
Use CONFIGURE/Switches, select System/Network Time Protocol, Add NTP Server and click GO to
access this page.
This page allows you to add a new NTP Server template to the Alcatel OmniAccess Switch or Appliance
configuration:
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 132
Use the checkbox to select one or more Third-Party APs.
Third-Party AP IP Address. Blank if obtaining IP Address from a DHCP
server. Click to edit
New Edit.
Third-Party AP MAC address.
Checkbox indicating whether 802.1X is enabled or disabled.
Alcatel OmniAccess Switch or Appliance interface port.
Configure <IPaddr> > Connected Third Party AP >
Configure <IPaddr> > Connected Third Party AP > New
Description
Configure <IPaddr> > Connected Third Party AP >
Configure <IPaddr> > Connected Third Party AP > New
Template.
New.
Configure <IPaddr> > NTP Servers > Add From Template