Configure <Ipaddr> > Alcatel Omniaccess Ap; Configure <Ipaddr> > Connected Third Party Ap - Alcatel OmniAccess Wireless System 2.1 Product Manual

Command Buttons
•
Save
•
Audit
Configure <IPaddr> > Alcatel OmniAccess AP
Use CONFIGURE/Switches and click an IP address under the IP Address column, then on the left
sidebar menu, select Access Points and click OmniAccess AP Access Points to access this page.
This page displays information about OmniAccess AP Access Points:
Table -
OmniAccess AP 1200 or 1250
Parameter
Name
MAC Address
Admin Status
AP Mode
Software Version
Primary Switch Name
After the OmniAccess AP 1200 or 1250 is reset, it will attempt to connect with its Primary
Note:
Alcatel OmniAccess Switch or Appliance as configured on this page. If the OmniAccess AP 1200 or
1250's Primary Alcatel OmniAccess Switch or Appliance is not available, it will search for the Master
Alcatel OmniAccess Switch or Appliance, and finally the least loaded Alcatel OmniAccess Switch or
Appliance on the network.
Configure <IPaddr> > Connected Third Party AP
Use CONFIGURE/Switches and click an IP address under the IP Address column, then on the left
sidebar menu, select Access Points and click Third Party APs to access this page.
Note that the Standalone WPS Alcatel OmniAccess Wireless System described in About the Alcatel
OmniAccess Wireless System in the Alcatel OmniAccess Wireless Product Guide does not support
Third-Party APs.
This page lists the Cisco 1200, Cisco 350 and ORiNOCO 2000 Access Points directly connected to your
4012 or 4024 Alcatel OmniAccess WLAN Switch:
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 131
Customer definable name of the OmniAccess AP 1200 or 1250. Refer to
Configure Access Points > Access Point >
Media Access Control address of the OmniAccess AP 1200 or 1250.
Administration state of the OmniAccess AP 1200 or 1250 is either enabled
or disabled.
Indicates the state of the OmniAccess AP 1200 or 1250 Monitor mode
(monitor for rogue access points without allowing clients to associate):
either local, OmniAccess AP 1200R or 1250R or Monitor.
In order for Alcatel OmniAccess Remote Edge Access Points
Note:
(OmniAccess 1200R APs) to operate correctly, this parameter must be set
to OmniAccess AP 1200R or 1250R.
Displays the Software version, for example, 1.3.25.5.
This is the OmniAccess AP 1200 or 1250's Primary Alcatel OmniAccess
Switch or Appliance SNMP name. The OmniAccess AP 1200 or 1250
attempts to associate with this Alcatel OmniAccess Switch or Appliance
first for all network operations and in the event of a hardware reset
(Note).
Configure <IPaddr> > Alcatel OmniAccess AP
Configure <IPaddr> > Alcatel OmniAccess AP
Description
<name>.
Configure <IPaddr> > Connected Third Party AP