Configure <Ipaddr> > Mac Filters > Add From Template - Alcatel OmniAccess Wireless System 2.1 Product Manual

Note that the Standalone WPS Alcatel OmniAccess Wireless System described in About the Alcatel
OmniAccess Wireless System in the Alcatel OmniAccess Wireless Product Guide does not support data
or voice clients.
This page allows you to add a new MAC Filter Template.
Table -
General Properties
Parameter
Import From File
File Path
MAC Address
SSID
Description
Command Buttons
•
Save
•
Cancel
Configure <IPaddr> > MAC Filters > Add From Template
Use CONFIGURE/Switches, click an IP address under the IP Address column, on the left sidebar
menu select Security/MAC Filtering, then select Add MAC Filter and click GO to access this page.
Note that the Standalone WPS Alcatel OmniAccess Wireless System described in About the Alcatel
OmniAccess Wireless System in the Alcatel OmniAccess Wireless Product Guide does not support data
or voice clients.
This page allows you to add a new MAC Filter from an existing MAC Filter Template.
•
Select a template to create from: Use the pulldown to select an already existing template
name.
Note:
> New
Command Buttons
Command Buttons
•
Create
•
Cancel
General
•
MAC Address (read only): OmniAccess AP 1200 or 1250 MAC address.
•
No of Switches Applied To (read only): Number of Alcatel OmniAccess Switches and Appliances
to which this template is applied.
•
SSID: Service Set Identifier being broadcast by a WLAN, or Any SSID.
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 152
Checkbox. Checkmark to display the File Path selection.
(Only available when the Import From File checkbox is checkmarked.)
Enter a file and pathname, or click the Browse button to select a CSV file
and pathname for a client MAC address.
(Only available when the Import From File checkbox is not checkmarked.)
Enter a client MAC address.
Select the SSID which to this MAC Filter is to be applied, or select Any
SSID.
Optionally enter a user-defined description.
You can also create a New Template. Refer to
Template.
Configure <IPaddr> > MAC Filters > Add From Template
Description
Configure <IPaddr> > MAC Filters > Add From Template
Configure MAC Filter Templates