Mode - Alcatel OmniAccess Wireless System 2.1 Product Manual

If the Alcatel OmniAccess Wireless System is operating in Layer 2 Mode, the
face will not be listed. Either skip this section and continue with
Deleting Operator-Defined
System from Layer 2 to Layer 3
•
Use the show interface detailed ap-manager command to view the current AP-Manager
Interface settings.
•
To change any of the parameters, disable all WLANs. Note that the Standalone WPS Alcatel
OmniAccess Wireless System described in
not support WLANs or Third-Party APs.
>show wlan summary
>config wlan disable <1-16, or 17 for Third-Party APs> (repeat for all enabled
WLANs)
•
And then use the following:
>config interface address ap-manager <IP addr> <IP netmask> [optional
gateway]
>config interface vlan ap-manager <VLAN ID|'0' for untagged>
>config interface port ap-manager <Physical DS Port Number>
>config interface dhcp ap-manager <IP addr of Primary DHCP server> <IP addr
of optional Secondary DHCP server>
>config interface acl ap-manager <Access Control List Name> (Note)
using the values collected from the network planner in
Appliance Parameters.
Note:
you must first configure the ACL using the
Note that the Standalone WPS Alcatel OmniAccess Wireless System described in
About the Alcatel OmniAccess Wireless System in the Alcatel OmniAccess Wireless
Product Guide does not support ACLs.
Use the show interface detailed ap-manager command to verify that the Alcatel OmniAccess Switch
or Appliance has correctly stored your inputs. Note that this Interface cannot be deleted. Continue with
the next section.
Creating, Assigning and Deleting Operator-Defined Interfaces
Each Alcatel OmniAccess Switch and Appliance can support up to 64 dynamic
faces. Each Operator-Defined Interface controls VLAN and other communications between Alcatel
OmniAccess WLAN Switches and Appliances and all other network devices. Between one and 64 Oper-
ator-Defined Interfaces can be assigned to
Layer 2 Management Interface, and the Layer 3
Note:
OmniAccess Switch or Appliance front-panel
CAUTION:
Operator-Defined Interface name contains a space, you may not be able to edit its
configuration using the
•
Use the show interface summary command to view the current Operator-Defined Interfaces.
They can be identified by the 'dynamic' Interface type.
11/5/04 Configuring Alcatel OmniAccess Switch and Appliance Interfaces
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 107
Interfaces, or go to

Mode.

If you are applying an Access Control List (ACL) to the Management Interface,
Alcatel
Operator-Defined Interfaces cannot be assigned to the dedicated Alcatel
Operator-Defined Interface names cannot have spaces in them. If an
Command Line
Converting an Alcatel OmniAccess Wireless
About the Alcatel OmniAccess Wireless System
Collecting Alcatel OmniAccess Switch or
Creating Access Control Lists
Creating, Assigning and Deleting Operator-Defined Interfaces
WLANs, physical Distribution System
AP-Manager Interface.
Service Port.
Interface.
ap-manager
Creating, Assigning and
section.
Operator-Defined Inter-
Ports, the
inter-
does