Alcatel OmniAccess Wireless System 2.1 Product Manual page 86

varies its transmit power and channel selection under control of the
performs the same Rogue AP location as any other OmniAccess AP 1200 or 1250.
Note that the OmniAccess AP 1200R or 1250R can support multiple WLANs while it is connected to its
Alcatel OmniAccess Switch or Appliance. However, when it loses connection to its Alcatel OmniAccess
Switch or Appliance, it supports only one WLAN on its local subnet.
The following figure shows a typical OmniAccess AP 1200R or 1250R configuration:
Note that the OmniAccess AP 1200R or 1250R must have a DHCP server available on its local subnet,
so it can obtain an IP address upon reboot. Also note that the OmniAccess 1200R APs at each remote
location must be on the same subnet to allow client roaming.
Refer to the following for more information on OmniAccess AP Access Points:
•
OmniAccess AP Access Points
•
OmniAccess AP 1200 or 1250 Models
•
OmniAccess AP 1200 or 1250 External and Internal Antennas
•
OmniAccess AP 1200 or 1250 LEDs
•
OmniAccess AP 1200 or 1250 Connectors
•
OmniAccess AP 1200 or 1250 Power Requirements
•
OmniAccess AP 1200 or 1250 External Power Supply
•
OmniAccess AP 1200 or 1250 Mounting Options
•
OmniAccess AP 1200 or 1250 Physical Security
•
Monitor Mode
•
OmniAccess AP 1200 or 1250 Deployment Guide
11/5/04 Alcatel OmniAccess Remote Edge Access Points (OmniAccess 1200R APs)
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 45
OmniVista AirView Software, and