-
IP Addresses: Local network IP Address of the Alcatel OmniAccess Switch or Appliance
Management Interface, described in the Alcatel OmniAccess Wireless Product Guide.
-
Switch Name: The user-defined name for the Alcatel OmniAccess Switch or Appliance.
-
Networks: Networks available.
•
Enter Switch IP Address (only when IP Address is selected): Enter the Alcatel OmniAccess
Switch or Appliance IP address.
•
Enter Switch Name (only when Switch Name is selected): Enter the user-defined Alcatel
OmniAccess Switch or Appliance name.
•
Select a Network (only when Networks is selected): Select All Networks or xxx.xxx.xxx.xxx.
•
Search button.
MONITOR/MAPS MENU BAR SELECTION
This menu bar selection provides access to the Alcatel OmniAccess Switch or Appliance maps summary
details. Use the selector area to access the respective network details. Making this selection from the
menu bar displays the
Monitor Maps
Monitor Maps
Use MONITOR/Maps to access this page.
This menu bar selection provides access to the Alcatel OmniAccess Switch or Appliance map displays
and details. Use this screen to create a campus (then add outdoor areas, or buildings and floors), or a
building (then add floors) upon which to place Access Points. Note that the campus map files can be
anywhere in your file system, and that the map files are automatically backed up when ACS Software is
backed up.
The following information appears on the Maps Page:
•
Name: Click any Name in the list. Refer to
<campus> > <building>
•
Type: Map type--Campus or Building.
•
Status: A colored icon indicating the campus or building status (green for Up, yellow for
Warning, or red for Down).
Right Command pulldown
Select a command and click GO:
•
New Campus: Refer to
•
New Building: To create a new building without a campus, refer to
Building.
•
Properties: Select to go to
•
RF Calibration Models: Refer to
•
GO (button).
Left sidebar
•
Search for (pulldown): All Maps, Campuses, Buildings, Floor Areas, Outdoor Areas, Access
Points.
•
Enter Name (text).
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 31
Monitor Maps
page.
or
Monitor Maps >
Configure Maps > New
Monitor Maps >
Monitor RF Calibration
MONITOR/MAPS MENU BAR SELECTION
MONITOR/MAPS MENU BAR SELECTION
Monitor Maps >
<campus>,
<building>.
Campus.
Properties.
Models.
Monitor Maps >
Configure Maps > New
Need help?
Do you have a question about the OmniAccess Wireless System 2.1 and is the answer not in the manual?