Alcatel OmniAccess Wireless System 2.1 Product Manual page 150

•
To change any of the parameters, disable all WLANs. Note that the Standalone WPS Alcatel
OmniAccess Wireless System described in
not support WLANs or Third-Party APs.
>show wlan summary
>config wlan disable <1-16, or 17 for Third-Party APs> (repeat for all enabled
WLANs)
•
And then use the following:
>config interface address virtual <IP addr> where <IP addr> is any fictitious,
unassigned, unused Gateway IP Address.
>config interface hostname virtual <DNS Host Name>
using the values collected from the network planner in
Appliance Parameters.
Note:
Access Switch or Appliance and save the configuration as described in
Alcatel OmniAccess Switch or
Use the show interface detailed virtual command to verify that the Alcatel OmniAccess Switch or
Appliance has correctly stored your inputs. Note that this Interface cannot be deleted. Continue with
the next section.
Enabling Web and Secure Web Modes
•
Use the following commands to enable (default) or disable the Distribution System port as a
Web port and/or a Secure Web port:
>config network webmode [enable/disable]
>config network secureweb [enable/disable]
Use the show network command to verify that your inputs were accepted. Continue with the next
parameter.
Configuring Spanning Tree Protocol
Spanning Tree Protocol is initially disabled for the Distribution System (network) ports. You can enable
STP on the Alcatel OmniAccess Switch or Appliance for all physical ports using the following commands.
If you are not configuring Spanning Tree Protocol at this time, skip this section.
•
Use the show spanningtree port and show spanningtree switch commands to view the
current STP status.
•
Disable STP on the Alcatel OmniAccess Switch or Appliance by entering:
>config spanningtree switch mode disable
This causes the Alcatel OmniAccess Switch or Appliance to disable support for STP on all ports.
Note:
disabled until you have finished configuring all associated parameters.
•
Configure the STP port administrative mode on the desired ports using one of the following
commands:
>config spanningtree port mode 802.1d [<port number>/all] (default)
>config spanningtree port mode fast [<port number>/all]
>config spanningtree port mode off <[<port number>/all]
where <port number> = 1 through 13 or 1 through 25, and all = all ports.
11/5/04 Configuring Alcatel OmniAccess Switch and Appliance Interfaces
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 109
If you change any of the Virtual Interface settings, reset the Alcatel Omni-
Enabling Web and Secure Web Modes
Configuring Spanning Tree Protocol
STP must be disabled before the STP parameters can be changed; leave STP
About the Alcatel OmniAccess Wireless System
Collecting Alcatel OmniAccess Switch or
Appliance.
does
Resetting the