Alcatel OmniAccess Wireless System 2.1 Product Manual page 321

•
config radius callStationIdType
•
config rogue ap
•
config rogue adhoc
•
config rogue client
•
config route
•
config serial
•
config sessions
•
config snmp community
•
config snmp syscontact
•
config snmp syslocation
•
config snmp trapreceiver
•
config snmp v3user
•
config snmp version
•
config spanning tree port
•
config spanningtree switch
•
config switchconfig
•
config syslog
•
config sysname
•
config time
•
config trapflags
•
config watchlist
•
config wlan
•
config wps
config rogue ap
config rogue ap
To configure the status of a rogue access point, use the config rogue ap command.
>config rogue ap <acknowledged/alert/contain/known> <MAC address> <num of
APs>
Syntax
Defaults
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 60
config
rogue ap
acknowledged
alert
contain
known
<MAC address>
<num of APs>
(none)
Configure parameters.
Rogue AP status.
This AP has been identified and belongs to an
external network.
This AP has not been identified. Generates a trap
upon detection of this access point.
Start containing a rogue access point.
This AP has been identified and is part of an internal
network.
MAC address of the AP.
Number of APs.
config rogue ap