Third-Party Aps > Edit - Alcatel OmniAccess Wireless System 2.1 Product Manual

Note that the Standalone WPS Alcatel OmniAccess Wireless System described in
OmniAccess Wireless SystemAbout the Alcatel OmniAccess Wireless System in the
Wireless Product GuideAlcatel OmniAccess Wireless Product Guide does not support Third-Party APs.
Use this page to enter the Cisco 1200, Cisco 350 and ORiNOCO 2000 Access Points connected to your
4012 or 4024 Alcatel OmniAccess WLAN Switch by:
•
AP MAC address.
•
Port Number is the front-panel physical port on the 4012 or 4024 Alcatel OmniAccess WLAN
Switch.
•
IP Address (leave blank to have the AP obtain its IP address from a DHCP server).
•
Whether 802.1X is enabled or disabled.
•
Whether Port Mirroring Mode is enabled or disabled, as described in the
Mirroring section in the
Product Guide.
Refer to Third-Party Access
GuideAlcatel OmniAccess Wireless Product Guide for more information.
Command Buttons
•
Back: Return to the previous window.
•
Apply: Data is sent to the Alcatel OmniAccess WLAN Switch and made to take effect, but not
preserved across a power cycle; these parameters are stored temporarily in volatile RAM.
•
Help: Request that the help page be displayed in a new browser window.
Third-Party APs > Edit
Use WIRELESS/Access Points/Third Party APs and then Edit to navigate to this page.
Note that the Standalone WPS Alcatel OmniAccess Wireless System described in
OmniAccess Wireless SystemAbout the Alcatel OmniAccess Wireless System in the
Wireless Product GuideAlcatel OmniAccess Wireless Product Guide does not support Third-Party APs.
Use this page to configure parameters for the Cisco 1200, Cisco 350 and ORiNOCO 2000 Access Points
connected to your 4012 or 4024 Alcatel OmniAccess WLAN Switch by:
•
AP MAC address (read only).
•
Port Number (read only).
•
IP address (read only).
•
Whether 802.1X is enabled or disabled (read only).
•
Set Port Mirroring Mode to enabled or disabled, as described in the
section in the
Guide.
Refer to Third-Party Access
GuideAlcatel OmniAccess Wireless Product Guide for more information.
Command Buttons
•
Back: Return to the previous window.
•
Apply: Data is sent to the Alcatel OmniAccess WLAN Switch and made to take effect, but not
preserved across a power cycle; these parameters are stored temporarily in volatile RAM.
•
Help: Request that the help page be displayed in a new browser window.
11/5/04
90-100831-300 Rev 2Alcatel OmniAccess Wireless Access Point Quick Installation Guide 75
Alcatel OmniAccess Wireless Product
PointsThird-Party Access Points in the
Third-Party APs > Edit
Alcatel OmniAccess Wireless Product
PointsThird-Party Access Points in the
About the Alcatel
Port
GuideAlcatel OmniAccess Wireless
Alcatel OmniAccess Wireless Product
About the Alcatel
Port MirroringPort Mirroring
GuideAlcatel OmniAccess Wireless Product
Alcatel OmniAccess Wireless Product
Third-Party APs > Edit
Alcatel OmniAccess
MirroringPort
Alcatel OmniAccess