Local Ip Identity - Juniper JUNOSE SOFTWARE 11.0.X - COMMAND REFERENCE A TO M 1-11-2010 Command Reference Manual

JUNOSe 11.0.x Command Reference Guide A to M

local ip identity

local ip identity
Syntax
{ address ipAddress | range ipRangeLow ipRangeHigh | subnet netAddress netMask }
no local ip identity
Command introduced in JUNOSe Release 7.3.0.
Release Information
Overrides the local identity (phase 2 identity) used for IPSec security association
Description
negotiations. For IPSec negotiations to succeed, the local and peer identities at one
end of the tunnel must match the peer and local identities at the other end
(respectively). The no version restores the default value, wildcard network value
0.0.0.0/0.
Options
IPSec Tunnel Profile Configuration
Mode
1218
local ip identity
ipAddress IP address used as the local identity for IPSec security association
negotiations
ipRangeLow—Low end of a range used as the local identity for IPSec security
association negotiations
ipRangeHigh—High end of a range used as the local identity for IPSec security
association negotiations
netAddress—IP network address used as the local identity for IPSec security
association negotiations
netMask—IP network mask used as the local identity for IPSec security association
negotiations