Authentication Mode - Juniper JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010 Command Reference Manual
Software for e series broadband services routers command reference a to m
Hide thumbs
Also See for JUNOSE SOFTWARE 11.2.X - XML MANAGEMENT PROTOCOL GUIDE 6-30-2010:
- Manual (282 pages)
Table of Contents
Advertisement
JunosE 11.2.x Command Reference Guide A to M
authentication mode
Syntax
Release Information
Description
Options
Mode
196
authentication mode { text | md5 keyID }
no authentication mode
Command introduced before JunosE Release 7.1.0.
Specifies the type of authentication used on the RIP remote-neighbor interface.
Authentication is disabled by default. The no version removes authentication from the
interface. Supported only in RIP version 2.
text—Sends a simple text password with each RIP message; if the password is not
possessed by remote neighbors, the message is rejected
md5—Encrypts and compresses the RIP message with MD5 message-digest algorithms
keyID—Number identifying the MD5 key in the range 1–255; remote neighbors must
share the MD5 key to decrypt the message and encrypt the response
Remote Neighbor Configuration
Copyright © 2010, Juniper Networks, Inc.
Advertisement
Table of Contents
