Vrrp Ipv6 Vrid Priority - 3Com S7906E Command Reference Manual

6300 series
Hide thumbs Also See for S7906E:
Table of Contents

Advertisement

Description
Use the vrrp ipv6 vrid preempt-mode command to configure preemption on the switch and configure
its preemption delay in the specified VRRP group.
Use the undo vrrp ipv6 vrid preempt-mode command to disable preemption on the switch in the
specified VRRP group.
Use the undo vrrp ipv6 vrid preempt-mode timer delay command to restore the default preemption
delay, that is, zero seconds.
The default mode is immediate preemption without delay.
If you set the switch in the VRRP group to work in non-preemptive mode, the delay period changes to
zero seconds automatically.
To avoid members in a VRRP group from changing their states frequently and make backups have
enough time to collect information (such as routing information), each backup waits for a period of time
(the preemption delay time) after it receives an advertisement with the priority lower than the local
priority, then sends VRRP advertisements to start a new master election in the VRRP group and finally
becomes the master.
Note that before executing the command, you need to create a VRRP group on an interface and
configure the virtual IPv6 address of the VRRP group.
Examples
# Enable preemption on the switch in VRRP group 80 and set the preemption delay to five seconds.
<Sysname> system-view
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] vrrp ipv6 vrid 80 virtual-ip fe80::2 link-local
[Sysname-Vlan-interface2] vrrp ipv6 vrid 80 preempt-mode timer delay 5

vrrp ipv6 vrid priority

Syntax
vrrp ipv6 vrid virtual-router-id priority priority-value
undo vrrp ipv6 vrid virtual-router-id priority
View
Interface view
Default Level
2: System level
Parameters
virtual-router-id: VRRP group number, in the range 1 to 255.
priority-value: Priority value of the switch in the specified VRRP group, in the range 1 to 254. A higher
number indicates a higher priority.
Description
Use the vrrp ipv6 vrid priority command to configure the priority of the switch in the specified VRRP
group.
1-21

Advertisement

Chapters

Table of Contents
loading
Need help?

Need help?

Do you have a question about the S7906E and is the answer not in the manual?

Questions and answers

This manual is also suitable for:

S7910eS7906e-vS7903eS7903e-sS7902e

Table of Contents