Lldp Hold-Multiplier - H3C MSR Series Command Reference Manual

Views
System view
Default command level
2: System level
Parameters
count: Sets the number of the LLDPDUs sent each time fast LLDPDU transmission is triggered. The
value range is 1 to 10.
Examples
# Configure the device to send four LLDPDUs each time fast LLDPDU transmission is triggered.
<Sysname> system-view
[Sysname] lldp fast-count 4

lldp hold-multiplier

Use lldp hold-multiplier to set the TTL multiplier.
Use undo lldp hold-multiplier to restore the default.
Syntax
lldp hold-multiplier value
undo lldp hold-multiplier
Default
The TTL multiplier is 4.
Views
System view
Default command level
2: System level
Parameters
value: Sets the TTL multiplier in the range of 2 to 10.
Usage guidelines
You can set the TTL of the local device information by configuring the TTL multiplier.
The TTL configuration of a device is determined by the expression:
TTL multiplier × LLDPDU transmit interval
The TTL can be up to 65535 seconds. Longer TTLs will be rounded off to 65535 seconds.
Examples
# Set the TTL multiplier to 6.
<Sysname> system-view
[Sysname] lldp hold-multiplier 6
Related commands
lldp timer tx-interval
143