C
10: C
286
HAPTER
ONFIGURING THE
LECS Address
Display Resident LECS
Address
LECS ADDR is: 47.0.0.0.0.0.3c.0.0.a0.0.0.0.0.a0.3e.0.0.1.0
LAN E
C
MULATION
ONFIGURATION
The following commands allow you to configure the resident LECS
address.
Display Resident LECS Address
Update Resident LECS Address
Wait for three minutes after each LECS update operation before
rebooting the switch to allow the change to be stored in flash.
Displays the address of the resident LECS.
Command Actions
Enter menu sequence:
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
2 1 1
The information shown below is displayed. The first 13 bytes represent
the network prefix of the CoreBuilder 7000 family ATM switch while the
last 7 bytes represent the user part.
Network prefix
S
(LECS)
ERVICE
(2) LEM: LAN Emulation
(1) LCS: LE Config Service
(1) LGA: Get resident LECS address
2 1 1
The address of the resident LECS is displayed.
Information is displayed as shown in the example
below.
User part