Reset All Configuration Parameters Except Ip Address - 3Com CoreBuilder 7000 Management Manual

C 4: C
90
HAPTER ONFIGURING AND
Reset All
Configuration
Parameters Except IP
Address
M S
ANAGING THE WITCH
Resets all configuration parameters for the CoreBuilder 7000 family ATM
switch to their factory default settings except for the IP address. Use this
command when you need to retain Telnet connectivity while resetting the
parameters.
See Table 15 for a list of factory default values for configuration
parameters.
It is recommended to perform this command when the switch is off-line.
After executing this command the switch is automatically rebooted. The
switch is configured after rebooting.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Continue prompt
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
3
1 2
The following prompt is displayed:
This will reset all configuration to factory defaults, except
IP configuration. Then the switch will reboot.
Are you sure? (Y/N)? Y
Enter to confirm,
Y N
M
ODULES
(2) FLS: Flash setup
(3) REI: Reset all configs except IP
Format or Range
y or n
1 2 3
All configuration parameters except for the IP address
are reset to their factory default values.
All configuration parameters are reset
to their factory values.
to cancel reset.