Set Node Administrative Status To Up - 3Com CoreBuilder 7000 Management Manual

C 13: C
378
HAPTER ONFIGURING AND
Set Node
Administrative Status
to UP
M PNNI (F
ANAGING
Updates the administrative status of the PNNI node to UP. The change
takes place immediately and is saved in flash memory for the next reboot.
Command Actions
Enter menu sequence:
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 10 4 3 2 2
The following message is displayed:
Node 1 of 1. PNNI Node Administrative Status is set to UP.
The PNNI node administrative status is set to UP.
E V O
OR THE XTENDED ERSION
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(2) ADM: Admin Status
(2) SSU: Set Node Admin Status to
1 1 10 4 3 2 2
The PNNI node administrative status is set to UP. The
change takes place immediately. The number and
administrative status of the PNNI node are displayed.
Node <m> of <n>. PNNI Node
Administrative Status is set to UP.
)
NLY
UP