Set Hello Interval
Sets the Hello interval value. In the absence of triggered Hellos, the
specified node will send one Hello packet on each of its ports every
"interval" seconds. A change to the Hello interval value takes place after
the next reboot.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Parameter
interval
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 10 4 3 4 3 5
The following message is displayed:
Default Value is 15 (15 sec), new value is 5
Press ENTER to continue...
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(4) TIM: Timers
(3) HIN: Hello Interval
Format or Range
1 - 30000 seconds
1 1 10 4 3 4 3 [parameters]
The Hello holddown timer values is displayed and is
updated to its new value.
Default value is <x>, new value is <y>
Setting the Timers
399