Display Atm-Layer Vpi/Vci Statistics - 3Com CoreBuilder 7000 Management Manual

C 8: V
240
HAPTER IEWING
Display ATM-Layer
VPI/VCI Statistics
S
TATISTICS
Displays the ATM layer statistics for a VPI/VCI of a specified port. If the
VPI/VCI is in a point-to-multipoint call the transmit or receive information
is not always applicable, as it is for a call in one direction only. This
command is applicable to the CoreBuilder 7X00 Interface Cards only for
the receive direction.
The counters count for a certain VPI/VCI by separating the cells into those
with CLP set and those with CLP clear.
Command Actions
Enter the menu sequence: (4) STS: Statistics
Enter a parameter at the prompt
Parameter
Port ID
VPI
VCI
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
4 3 2 3.2 0 188
The ATM statistics for port <3.2> and VPI/VCI = 0/188 are displayed.
(3) ATM: ATM layer
(2) VPC: Stats per VPI/VCI
Format or Range
slot.port
0-7
32-512
4 3 2 [parameters]
ATM-layer statistics for the specified port and VPI/VCI
are displayed.
Information is displayed as shown in the example
below.