Set Retransmit Interval - 3Com CoreBuilder 7000 Management Manual

Set Retransmit Sets the retransmit interval. The retransmit interval is the time after which
Interval unacknowledged PTSEs will be retransmitted. A change to the retransmit
interval takes place after the next reboot.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
The following message is displayed:
Default Value is 5, new value is 1
Press ENTER to continue...
Parameter
interval
1 1 10 4 3 4 7 1
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(4) TIM: Timers
(7) RTI: Retransmit Interval
Format or Range
1 - 60000 seconds
1 1 10 4 3 4 7 [parameters]
The retransmit interval is displayed and is updated to
its new value.
Default value is <x>, new value is <y>
Setting the Timers 403