Set Cache State For Add Party - 3Com CoreBuilder 7000 Management Manual

Set Cache State for
ADD PARTY
Determines whether or not the last cache accumulated for a route
(between a specific source and any destination that has previously been
accessed) will continue to be used when an ADD PARTY route is added
(Save) or will be reinitialized (Drop). The default cache state for ADD
PARTY is Save. If the cache refresh is dropped, all caches for recently
calculated routes will be reinitialized. A change to the cache refresh status
takes place immediately.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Parameter
Include Add Party Route
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 10 4 6 4 1
The following message is displayed:
Drop Cache after ADD PARTY route calculation.
Press ENTER to continue...
Configuring the Route Cache
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(6) SCR: Set Route Cache (UBR)
Configuration
(4) GCS: Set Cache Refresh for
ADD PARTY
Format or Range
0 - save
1 - drop
1 1 10 4 6 4
The PNNI cache is updated/not updated when an ADD
PARTY route is calculated.
Save/Drop PNNI cache - when ADD PARTY
route is calculated.
443