Force I/F for
Redundancy
Communication
Slot id
Slot status
-------
-----------
->
3
Occupied
5
Occupied
6
Occupied
The following message appears:
Standby mode is invoked.
Specifies the slot number of the interface card to be used for redundancy
communication.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Slot id
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 13 4
The following prompt is displayed:
Enter parameter(s): Enter slot id(3-6)
Enter 3 to specify the slot number of the interface card to be used for
redundancy communication.
The following information is displayed:
I/F card type
-------------------
8 port ATM I/F card
8 port ATM I/F card
7400 Ethernet/ATM module
(1) SET: Switch setup
(13) SRS: Switch Redundancy setup
(4) SIR: Force I/F for red. comm.
Range
3 - 6
1 1 13 4
The interface card in the specified slot becomes the
card used for redundancy communication.
The information shown in the example is displayed.
I/F card status
---------------
Switch Redundancy
67
Up
Up
Up