Display Auto-Discovery Status - 3Com CoreBuilder 7000 Management Manual

C 6: ILMI C
132
HAPTER
Display
Auto-Discovery
Status
ONFIGURATION
Displays the auto-discovery status for the specified port of the
CoreBuilder 7000 family ATM switch. Auto-discovery determines, by
negotiation, the common protocol parameters ATM interface type and
IME type to be used on the ILMI channel. The status can be either
enabled or disabled. For more information about auto-discovery,
"Auto-Discovery" on page 43 in the Operations Guide.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Port ID
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 8 3 1 3.2
The auto-discovery status at port 3.2 is displayed as follows:
Auto-discovery is ENABLED.
(1) SET: Switch setup
(8) IME: ILMI setup
(3) AUC: Auto-discovery setup
(1) GET: Get Auto-discov. status
Format or Range
slot.port
1 1 8 3 1 [parameters]
The auto-discovery status for the specified port is
displayed.
Auto-discovery is ENABLED/DISABLED.