Update Ip Address - 3Com CoreBuilder 7000 Management Manual

Update IP Address

Enter the new IP address to update the IP address of the CoreBuilder
7000 family ATM switch. The default factory IP address is 0.0.0.0. The IP
address is changed after the next reboot of the switch.
Run the integrated fast setup to configure this parameter.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
IP Address
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 2 1 2 100.0.2.2
The IP address is updated to 100.0.2.2 after the next reboot.
It is essential to change the factory default IP address to match your
network addresses.
Setting Up for Management
(1) SET: Switch setup
(2) MNG: Management setup
(1) SIP: IP Setup
(2) SIP: Set & Save IP Address
Format or Range
valid IP address
1 1 2 1 2 [parameters]
The IP address is updated after the next reboot of the
switch.
Run integrated fast setup to configure
this parameter.
71