Enable/Disable Auto-Discovery - 3Com CoreBuilder 7000 Management Manual

Enable/Disable Enables or disables auto-discovery for the specified port in the
Auto-Discovery CoreBuilder 7000 family ATM switch. For more information about
auto-discovery, "Auto-Discovery" on page 43 in the Operations Guide.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
The following message is displayed:
Auto-discovery is set to ENABLED
The auto-discovery status of port 3.2 is enabled.
Parameter
Port ID
Auto-discovery
enable/disable
1 1 8 3 2 3.2 1
(1) SET: Switch setup
(8) IME: ILMI setup
(3) AUC: Auto-discovery setup
(2) SET: Set&save Auto-Config stat
Format or Range
slot.port
0 to disable auto-discovery
1 to enable auto-discovery
[parameters]
1 1 8 3 2
The auto-discovery status is updated for the selected
port immediately and is saved in flash.
Auto-discovery is set to
ENABLED/DISABLED
ILMI Setup 133