Enable Pnni And Disable E-Iisp - 3Com CoreBuilder 7000 Management Manual

Enable PNNI and
Disable E-IISP
Changes the status of the routing mode to PNNI and disables the E-IISP
status. A change to the status takes place after the next reboot.
Command Actions
Enter menu sequence:
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 10 2
The following message is displayed:
PNNI/E-IISP State is set to PNNI for the next reboot.
PNNI/E-IISP routing mode was set to PNNI for the next reboot.
The status of the routing mode is set to PNNI for the next reboot.
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(2) ENP: Enable PNNI, disable E-IISP
1 1 10 2
The PNNI/E-IISP state of the routing mode is set to
PNNI and the value is displayed.
PNNI/E-IISP State is set to PNNI for
the next reboot.
PNNI/E-IISP routing mode was set to
PNNI for the next reboot.
Setting Up for PNNI 101