Set Peer Group Id - 3Com CoreBuilder 7000 Management Manual

C 13: C
388
HAPTER ONFIGURING AND

Set Peer Group ID

M PNNI (F
ANAGING
Sets the Peer Group ID of the PNNI node. For more information on peer
groups, see "Organizing a Network Hierarchy" on page 71 in the
Operations Guide.
Currently the peer group ID cannot be changed via this option. To change
the peer group ID, the ATM address network prefix and node level should
be changed. See "Set ATM Address" on page 385 and "Set Node Level"
on page 382 in this chapter for details on how to change these.
Command Actions
Enter menu sequence:
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 10 4 3 3 3 2
The following message is displayed:
Peer Group ID can only be changed via the Node Level and ATM
address network prefix.
E V O
OR THE XTENDED ERSION
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(3) CHR: Characteristics
(3) PID: Peer Group ID
(2) SPI: Set Peer Group ID
1 1 10 4 3 3 3 2
None.
Peer Group ID can only be changed via
the Node Level and ATM address network
prefix.
)
NLY