Update Call-Proceeding Suppression - 3Com CoreBuilder 7000 Management Manual

C 7: C
208
HAPTER ONFIGURING
Update
CALL-PROCEEDING
Suppression
V C
IRTUAL HANNELS
Updates the signaling call-proceeding suppression facility and saves it in
flash memory. For more details, "Display CALL-PROCEEDING Suppression
Status" on page 207.
This command also causes the call-proceeding flag to be saved in flash
memory.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Call-proceeding message
enable/disable flag
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 4 6 2 1
The following message is displayed:
The call-proceeding flag was successfully set to on.
The call-proceeding enable flag is updated to ON and the new value is
saved in flash memory.
(1) SET: Switch setup
(4) SIG: Signaling setup
(6) CCL: Signaling call ctrl setup
(2) SET: Set & save call proc flag
Format or Range
0 to suppress call-proceeding messages
1 to send call-proceeding messages
1 1 4 6 2 [parameters]
The call-proceeding enable flag is updated. The new
value is saved in flash memory.
The call-proceeding flag was
successfully set to on/off.