Update Startup Delay - 3Com CoreBuilder 7000 Management Manual

Update Startup Delay

Updates the startup delay parameter for LANE redundancy facility in the
CoreBuilder 7000 family ATM switch. The startup delay is the time
elapsed between the switch startup and the startup of the LANE
redundancy facility.
To display the current value of the parameter, "Display LE Service
Redundancy" on page 263. This parameter is in the range 1–15 minutes
and defaults to 10 minutes. For more information about the startup
delay, see "LANE Redundancy Start-up Delay" on page 160 in the
Operations Guide.
The startup delay takes effect at the next reboot.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Parameter
Startup Delay
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 5 4 3 600
The following message is displayed:
Startup delay changed.
The startup delay for the LANE redundancy facility in the CoreBuilder
7000 family ATM switch is set to 600 seconds
LAN Emulation Redundancy Setup
(1) SYS: Platform config
(1) SET: Switch setup
(5) SLE: LE setup
(4) RDN: LE Service redundancy setup
(3) LRD: Set LES red. startup delay
Format or Range
Seconds
Default is 600 seconds.
1 1 5 4 3 [parameters]
The startup delay for the LANE redundancy facility is
set for the next reboot.
Startup delay changed.
.
265