Set Rcc Service Category - 3Com CoreBuilder 7000 Management Manual

Set RCC Service Sets the RCC service category parameter. The RCC service category is the
Category
service category used for the PNNI routing control channel (VCI = 18) on this
interface. See Table 54 for an explanation of the service category
parameters.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Direct access sequence:
Command Result
Example
Enter:
The following message is displayed:
Default value is 6, new value is set to 2
Press ENTER to continue...
Parameter
RCC service category
1 1 10 4 4 2 7 2
Setting Interface Parameters
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(4) ICF: Interface Configuration
(2) IPR: Interface Parameters
(7) RSC: RCC Service Category
Format or Range
2 - cbr
3 - rtVbr
4 - nrtVbr
5 - abr
6 - ubr
1 1 10 4 4 2 7 [parameters]
431