Setting Up For Pnni; Display Pnni/E-Iisp State - 3Com CoreBuilder 7000 Management Manual

C 4: C
100
HAPTER ONFIGURING AND

Setting Up for PNNI

Display PNNI/E-IISP
State
M S
ANAGING THE WITCH
The following commands allow you to set up the network for the PNNI
protocol.

Display PNNI/E-IISP State

Enable PNNI and Disable E-IISP
Enable E-IISP and Disable PNNI
PNNI is available in version 4.5 extended only. To order the extended
verision of this software, please contact your 3Com representitive.
Displays the PNNI/E-IISP status and the next reboot state. The status is
either PNNI or E-IISP.
Command Actions
Enter menu sequence:
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 10 1
The following message is displayed:
PNNI/E-IISP State: PNNI
Next reboot value: PNNI
M
ODULES
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(1) VPS: View PNNI/E-IISP State
1 1 10 1
The PNNI/E-IISP status and the next reboot value are
displayed.
PNNI/E-IISP State: <state>
Next reboot value: <state>