Signaling Setup
197
Update VPI/VCI
Updates the UNI (Q93B) VPI/VCI configuration parameters of the
Range
specified port for the current session. You set maximum and minimum
VPI/VCI values for each port. For more information, "Display VPI/VCI
Range" on page 195.
The default range is VPI: 0-7; VCI: 32-511.
When the ILMI auto-configuration procedure is enabled, the VPI/VCI
limits are determined automatically and override any settings made by
this command. For more information, "Display Auto-Configuration
Status" on page 130.
This command causes the new Q93B configuration parameters to be
activated in the current session but the new value is not stored in flash
until you use the SAV command which is described in the next section. If
the new value is not stored in flash, the system reverts to the previous
value of the Q93B configuration parameters the next time it reboots. See
the screen in the previous section.