Managing Switch Modules; Display Switch Modules - 3Com CoreBuilder 7000 Management Manual

Managing Switch
Modules
Display Switch
Modules
Enter to confirm,
Y N
parameters are reset to their factory values.
The login access level will be switched to read only until the next reboot.
See Table 14 for a description of the parameters.
The following command allows you to display switch module information
for the CoreBuilder 7000 family ATM switch.
Displays general information about each of the switch modules present –
1, 2, or both and detailed manufacturing information about the attached
module. If two switch modules are present in the same chassis, one is
used for redundancy. For more information about redundant switch
cards, see Chapter 10 in the Operations Guide.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Direct access sequence:
Command Result
System action taken:
System message display:
Example
This example is for a CoreBuilder 7000HD switch.
Enter:
1 4
Switch module information is displayed. See Table 16 for a description of
the information.
to cancel reset. The box profile configuration
(4) SWM: Switch modules
1 4
Switch module information is displayed.
See the example below and

Managing Switch Modules

Table 16
.
93