Setting Protocol Address Translation From Token Ring To Fddi - 3Com LANPLEX 6000 User Manual

Top-Level Menu
system
display
ethernet
mode
fddi
ipFragmentaion
tokenring
ipxSnapTranslation
bridge
trFDDIMode
ip
addressThreshold
snmp
agingTime
analyzer
stpState
script
stpPriority
logout
stpMaxAge
stpHelloTime
srBridgeNumber
port
packetFilter
Setting Protocol
Address
Translation from
Token Ring to
FDDI
Top-Level Menu
system
display
ethernet
mode
fddi
ipFragmentation
tokenring
ipxSnapTranslation
bridge
trFddiMode
ip
addressThreshold
snmp
agingTime
analyzer
stpState
script
stpPriority
logout
stpMaxAge
stpHelloTime
stpForwardDelay
srBridgeNumber
port
packetFilter

Setting Protocol Address Translation from Token Ring to FDDI

To enable or disable IPX Snap Translation for a bridge:
1 From the top level of the Administration Console, enter:
bridge ipxSnapTranslation
2 Enter the number(s) of the slot(s) or
3 To enable IPX Snap Translation on a bridge, enter:
enable
To disable IP Snap Translation on a bridge, enter:
disable
Embedded protocol addresses for Token Ring use the non-canonical format
while FDDI uses the canonical format. To provide interoperability, these
embedded addresses can be found and translated to their native formats on
TRSM for IP, IPX, NetBIOS and SNA protocols. It is necessary to do this for a
client on Token Ring to talk to a server on FDDI. It is unnecessary if FDDI is
used purely as a transport backbone. The default value for this parameter is
native address conversion.
This parameter is only available on Token Ring bridges.
To configure bridge protocol translation:
1 From the top level of the Administration Console, enter:
bridge trFddiMode
2 Enter the number(s) of the slot(s) or
3 Enter the protocol translation value
for all bridges in the system.
all
for all bridges in the system.
all
or
(native backbone).
12-7