Download Configuration Parameters - 3Com CoreBuilder 7000 Management Manual

Downloading System Software and Configuration 51
Load process of file type LECS Order List completed
successfully
Download Retrieves stored configuration parameters by performing TFTP
configuration download from disk to flash memory. Specify the server IP
Configuration
address and data file names. If single-IP mode is enabled, you can also
Parameters
use this command to download data to CoreBuilder 7X00 interface cards
installed in the same chassis (see "Enable/Disable Single-IP Mode" on
page 85). For more information, "Storing and Retrieving Configuration
Parameters" on page 75 in the Installation Guide .
When the configuration files are downloaded to flash memory, they
overwrite the previous information. The new parameters are not
activated immediately but only at the next reboot after they are read from
the flash memory.
Subsequent to a configuration download, all LMA set operations are
blocked until the next reboot—except for configuration
upload/download and reboot operations.
It is recommended, therefore, to perform a configuration download only
when you are ready to reboot and activate the new parameters.
Cards should not be 'hot swapped' after a configuration download until
after the next reboot.