Display Le Service Redundancy - 3Com CoreBuilder 7000 Management Manual

Display LE Service
Redundancy
Displays parameters of the LES redundancy facility in the CoreBuilder
7000 family ATM switch. For more information, see "LAN Emulation
Redundancy" on page 153 in the Operations Guide.
Command Actions
Enter menu sequence:
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 5 4 1
The following information is displayed:
LANE Service redundancy mechanism
Startup Delay (Sec)
Table 38 shows the LES Redundancy Parameters displayed by the
command.
.
Table 38 LES Redundancy Parameters
Name
LANE Service Redundancy Status
Startup Delay
LAN Emulation Redundancy Setup
(1) SYS: Platform config
(1) SET: Switch setup
(5) SLE: LE setup
(4) RDN: LE Service redundancy setup
(1) DLR: Show LES redundancy params
1 1 5 4 1
The LES redundancy parameters are displayed.
Information is displayed as shown in the example
below.
: Enabled
: 600
Description
Enable/disable status
Time elapsed between switch startup and
startup of LANE redundancy facility — in
seconds. Default is 600.
263