3Com CoreBuilder 7000 Management Manual page 143

Command Actions
Enter the menu sequence: (1) SYS: Platform config
Enter a parameter at the prompt
Parameter
Port ID
Direct access sequence:
Command Result
System action taken:
System message display:
Auto-Discovery Results Display
Table 20 describes the auto-discovery results displayed by the command.
.
Table 20 Auto-Discovery Results
Name Description
Parameter Name Protocol parameter configured by auto-discovery
Local Value Initial value of parameter in local switch
Remote Value Value of parameter returned from peer switch
AutoCfg Result Final value of parameter in local switch determined by
auto-discovery
Example
This example shows the results of auto-discovery of the ATM interface
type and IME type between the local switch and a peer switch. Initially,
port 3.3 of the local switch is configured to interface type E-IISP and the
adjacent port, 4.3, of the peer switch is configured to interface type IISP.
Auto-discovery acts to re-configure the peer switch to the lowest
common value: E-IISP.
(1) SET: Switch setup
(8) IME: ILMI setup
(6)ACV:Auto-Config/Auto-Dis View
(2) DIS: View Auto Disc result
Format or Range
slot.port
1 1 8 6 2 [parameters]
The auto-discovery results for the specified port is
displayed.
Information is displayed as shown in the example
below.
ILMI Setup 143