Display Vp Tunneling Mode - 3Com CoreBuilder 7000 Management Manual

Display VP Tunneling
Mode
Commands to define a VP tunnel at an enabled port
Display VP Tunnels at Port
Add VP Tunnel to Port
Remove VP Tunnel from Port
For more information about VP tunnels, see "VP Tunneling" on page
5-101.
Displays the VP tunneling mode of the CoreBuilder 7000 family ATM
switch. The mode can be enabled or disabled. VP tunnels can be
configured only if VP tunneling mode is enabled. For more information,
see "VP Tunneling" on page 5-101.
Command Actions
Enter the menu sequence: (1) SYS: Platform config
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 9 1 1
The following message is displayed:
VP TUNNELING mode is Disabled
Configuring VP Tunnels
(1) SET: Switch setup
(9) VPT: VP Tunneling Setup
(1) MOD: VP Tunneling Mode Setup
(1) GMD: VP Tunneling Get Mode
1 1 9 1 1
The VP tunneling mode of the CoreBuilder 7000 family
ATM switch is displayed.
VP TUNNELING mode is Enabled/Disabled
221