Set Flow Detection Protocols - 3Com CoreBuilder 7000 Management Manual

Set Flow Detection
Protocols
Sets the MPC-p3 flow detection protocols parameter.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Parameter
flow detection protocols 1 - NONE
Direct access sequence:
Command Result
System action taken:
System message display:
Example:
Enter: 2 5 2 4 3
The following message is displayed:
Parameter changed successfully.
The flow detection protocols parameter is set.
MPOA Devices Configuration
(2) LEM: LAN Emulation
(5) MPA: MPOA Devices Configuration
(2) MPC: MPOA Client Configuration
(4) MP3: Set flow detection protocols
Format or Range
2 - IP
3 - IPX
4 - IP+IPX
2 5 2 4 [parameters]
The flow detection protocols parameter is set.
Parameter changed successfully
281