Add Atm Address To Port - 3Com CoreBuilder 7000 Management Manual

C 6: ILMI C
160
HAPTER
Add ATM Address to
Port
ONFIGURATION
Adds an ATM address to the list of registered ATM addresses at a port.
Enter the port number and ATM address. Use this command, for
example, for IISP or E-IISP manual port configuration or for devices that
do not support IIMI.
Perform the command Save ATM Addresses to Flash ( "Save ATM
Addresses to Flash" on page 162 ) before the next reboot to ensure that
your changes are saved.
Command Actions
Enter the menu sequence: (3) CON: Connections
Enter a parameter at the prompt
Parameter
Port ID
ATM address
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
3 4 2 2 3.1
47.0.0.0.0.0.3c.0.0.b*.*.*
The following message is displayed.
Address already exists on port <6.1>, Use it again? (y/n) n
(4) S&C: Setup and Config Conns
(2) STP: Atm address setup
(2) ADD: Add ATM address
Format or Range
slot.port
19 bytes—When fewer, end with '.*'
3 4 2 2 [parameters]
The specified ATM address is added to specified port.
The change is not saved to flash memory.
Address was set for port.
.*.*.*.*.*.*.*.*