Display Ime Atm Addresses And Scope At Port - 3Com CoreBuilder 7000 Management Manual

C 6: ILMI C
156
HAPTER ONFIGURATION
Display IME ATM Displays UNI Management Entities (IME) registered ATM addresses with
Addresses and Scope organizational scope for specified ports of the switch. These ATM
at Port addresses were registered by end stations or edge devices attached to the
port using the ILMI address registration process. For more information,
"UNI Address Registration" on page 38 in the Operations Guide.
Addresses defined through LMA are not displayed by this command.
For easy reference, each ATM address registered at a port is assigned a
member ID . The member ID is made up of the <slot.port> number
followed by a two-digit number of the form 0n where 01 corresponds to
the first ATM address registered, 02 to the second and so on. For
example, the member ID for the first ATM address registered at port
<3.3> is 3301.
The member ID is useful for displaying information about calls which are
associated with the ATM address. For example, if a switched virtual
channel is established through to the LEC whose ATM address is
registered at the port, you use the member ID to reference that virtual
channel in order to display information about calls to the LEC on that
channel. For more information, "Display Call Routed to ATM Address" on
page 165.