Set Node Level - 3Com CoreBuilder 7000 Management Manual

C 13: C
382
HAPTER ONFIGURING AND

Set Node Level

M PNNI (F
ANAGING
Updates the current node level. The node level is the hierarchy level of the
peer group to which it belongs. For more information, see "Organizing a
Network Hierarchy" on page 71 in the Operations Guide. A change to
the node level takes place after the next reboot.
It is important not to split ELANs between groups when constructing the
network hierarchy.
There are several PNNI operations in the LMA that can only be performed
when the node administrative status is set to DOWN, and that take effect
immediately after the status is reset to UP. These include updating the
ATM address, updating the PNNI node id and updating the node level.For
more information, see "Set Node Administrative Status to DOWN" on
page 379.
Command Actions
Enter menu sequence:
Enter a parameter at the prompt
Parameter
PNNI node level
Direct access sequence:
Command Result
System action taken:
System message display:
Example
Enter:
1 1 10 4 3 3 1 2 80
The following message is displayed:
Node 1 of 1. Current Node Level is set to 80.
E V O
OR THE XTENDED ERSION
(1) SYS: Platform config
(1) SET: Switch setup
(10) PNI: PNNI Setup
(4) CFP: Configure PNNI
(3) NCF: Node Configuration
(3) CHR: Characteristics
(1) LEV: Level
(2) SNL: Set Node Level
Format or Range
0 to 104
1 1 10 4 3 3 1 2
The current node level is updated.
Node <x> of <y>. Current node level is
set to <n>.
)
NLY